LED Driver

Open-source flight controller board with RP2350B MCU, 10-DOF sensor suite (gyro, accelerometer, barometer, magnetometer), INA226 battery monitor, microSD with 4-bit SDIO, and DC-DC converter. 50.7x41.

Open-source ESP32 Teleinfo reader board for French Linky energy meters. Pre-flashed with Tasmota, features USB-C, WiFi, QWIIC I2C port, and RGB LED. Reads both Standard and Historique TIC formats.

Open-source ESP32-S3 camera board with PoE, microSD, and Stemma QT designed for AI-powered utility meter reading using the AI-on-the-edge-device firmware with TensorFlow Lite inference.

20-key open-source mechanical macropad with duckyScript engine, ESP32-S3, 1.5\" OLED, Bluetooth 5.0, hot-swap switches, dual rotary encoders, and microSD — a powerful Stream Deck alternative.

A low-cost, fully open source FPGA development board built on the Lattice ICE40UP5K with 5.3K LUTs, on-board FTDI FT232H USB programmer, 4MB qSPI flash, and 39 GPIO pins on PMOD-compatible headers.

ESP32-S3 based multi-mode BLE detection and security research tool with integrated piezo buzzer, MMCX antenna connector, and seven swappable firmware modes for surveillance detection, drone tracking,

ESP32 audio development board with TAS5805M I2S Class-D amplifier delivering 2x23W stereo output, designed for multi-room audio, network streaming, and smart home integration.

Compact, low-power ARM Cortex-M0+ development board with ATSAMD21G18 MCU, 16MB SPI flash, USB-C, WS2812 RGB LED, and FPC display connector, ideal for IoT and low-power applications.

Compact ESP32-E IoT microcontroller with WiFi 802.11 b/g/n, Bluetooth 4.2, 18 digital I/O, 11 analog inputs, 7 touch pins, 2 DACs, onboard WS2812 RGB LED, GDI display interface, and lithium battery ch

Ultra-compact USB-A plug-and-play development board with the Raspberry Pi RP2350A dual-architecture MCU, 4MB flash, WS2812 RGB LED, castellated module design, and 29 GPIO pins in a tiny 18 x 25.5mm fo

Ultra-compact castellated ESP32-H2 development board with BLE 5.2, Zigbee 3.0, Thread 1.3, and Matter support. USB-C powered with WS2812 RGB LED, 15 GPIO pins, and 4MB flash in a tiny 23.5 x 15.2mm fo

Industrial DIN-rail RP2350B controller with 8-channel relay outputs (10A/250VAC), 8 optocoupler-isolated digital inputs, W5500 Ethernet (optional PoE), isolated RS485, RTC, microSD, and 7-36V wide-vol

ESP32-S3 AI smart speaker development board with dual-microphone array, ES8311 audio codec, 7 surround RGB LEDs, RTC, camera and LCD expansion interfaces, and LiPo battery support for voice assistant

Industrial ESP32-S3 controller with 8-channel optocoupler-isolated digital inputs (5-36V), 8-channel Darlington outputs (500mA each), PoE Ethernet (W5500), isolated RS-485 and CAN bus, RTC, and DIN ra

Compact RP2350A development board with an 8x8 WS2812 addressable RGB LED matrix, QMI8658 6-axis IMU (accelerometer + gyroscope), 16MB flash, 25 GPIO pins, HSTX interface, and USB-C for interactive LED

Ultra-compact ESP32-H2 dev module with Thread 1.4, Zigbee 3.0, Matter, and BLE 5 — featuring a Grove port, IR transmitter, and RGB LED in a stamp-sized 23.5×12mm form factor.

Official Espressif development board for the ESP32-C6, combining WiFi 6, BLE 5, and IEEE 802.15.4 (Thread/Zigbee/Matter) on a RISC-V single-core SoC — ideal for Matter-native IoT and smart home develo

Ultra-compact ESP32-S3 dev board (24x24mm) with 0.85" IPS LCD, BMI270 IMU, BMM150 magnetometer, 8MB PSRAM, IR transmitter, LP5562 RGB LED driver, and Grove port for IoT and robotics.

Feature-rich ESP32 IoT dev kit with 2.0" IPS display, 8MB PSRAM, 16MB flash, MPU6886 IMU, BMM150 magnetometer, 10x SK6812 RGB LEDs, microphone, speaker, microSD, 500mAh battery, and M5GO charging base

Industrial ESP32 controller with 1.14" IPS LCD, 6 Grove ports, INA3221 power monitor, MPU6886 IMU, RTC, 7x SK6812 LEDs, dual 18650 battery holders, USB-A power output, and 16MB flash.

Ultra-low power LoRa/LoRaWAN development board based on the ASR6502 SiP (ARM Cortex-M0+ @ 48MHz + SX1262), with USB-C, solar panel support, and 3.5uA deep sleep current. Ideal for remote environmental

Arduino's flagship UNO board upgraded with Renesas RA4M1 ARM Cortex-M4F at 48MHz, ESP32-S3 WiFi/BLE 5.0, built-in 12×8 LED matrix, 12-bit DAC, CAN bus, op-amp, and Qwiic connector — all in the classic