Nordic nRF52840

nRF52840 + SX1262 LoRa + L76K GPS all-in-one board with 1.54-inch e-paper display, 850mAh battery, Thread, Zigbee, and BLE 5.0 — runs Meshtastic, SoftRF, and custom NRF firmware out of the box.

Enhanced T-Echo with nRF52840, SX1262 LoRa, L76K GPS, BHI260AP IMU, 2400mAh battery, 1.54-inch e-paper display, vibration motor, buzzer, and 1/4-inch mount — Meshtastic-ready with extended runtime.

Simplified T-Echo with nRF52840, SX1262 LoRa, and optional L76K GPS — a low-cost, low-power LoRa node and Meshtastic-compatible board for off-grid mesh networking.

Solar-powered nRF52840 + SX1262 LoRa dev board with integrated BMS supporting 1-4 cell lithium batteries, MPPT solar charging, and USB PD3.0. Designed for Meshtastic solar nodes.

High-power Meshtastic relay/repeater kit with nRF52840 + SX1262 LoRa, 18V/10W solar panel, 3x2800mAh battery pack, IP66 aluminum enclosure, and 5.5dBi fiberglass antenna.

Open-source NFC/RFID multi-tool built on the nRF52840 SoC. Reads, writes, cracks, and emulates 13.56MHz and 125kHz cards in a compact key-fob form factor with BLE 5.0 connectivity.

Compact Meshtastic LoRa transceiver with nRF52840, SX1262, 1.54\" e-paper display, GPS, and 1200mAh battery for off-grid mesh communication.

Open-source multi-protocol wireless USB dongle based on the Nordic nRF52840 SoC. Supports BLE 5.4, Thread, Zigbee, 802.15.4, NFC, and USB 2.0 with UF2 drag-and-drop bootloader. Priced at $12.99.

Pro Micro drop-in replacement wireless keyboard controller built on the nRF52840 with BLE 5.0, onboard LiPo charger, mid-mount USB-C, and UF2 bootloader. The most popular controller for ZMK wireless s

Round educational microcontroller with Nordic nRF52840 (64MHz Cortex-M4F + BLE), 10 NeoPixels, accelerometer, microphone, light sensor, speaker, 8 alligator-clip I/O pads, and USB. Runs CircuitPython,

Tiny breadboard-friendly Bluetooth LE board with Nordic nRF52840 Cortex-M4F @ 64MHz, 1MB Flash, 256KB RAM, 2MB QSPI Flash, 21 GPIO, and native USB — all in a 36×17.6mm footprint. Supports CircuitPytho

Sensor-rich BLE Feather with Nordic nRF52840 (64MHz Cortex-M4F), 6 onboard sensors (9-DoF IMU, magnetometer, proximity/light, PDM mic, humidity, barometric pressure), 21 GPIO, and FCC/IC/TELEC certifi

Feather board with nRF52840 ARM Cortex-M4F at 64MHz, BLE 5.0, native USB (CDC/HID/MIDI/MSC), 1MB flash, 256KB SRAM, 2MB QSPI flash, 21 GPIO, SWD debug, and LiPo charging. Supports Arduino and CircuitP

Qi2 magnetic wireless charging power bank with integrated Meshtastic mesh networking node, featuring nRF52840 BLE + SX1262 LoRa radio and a 2.13" e-ink display. Available in 5000mAh and 10000mAh confi

Compact nRF52840 + SX1262 LoRa development board with BLE 5.0, optional 1.14" TFT display and L76K GPS module. Designed for Meshtastic mesh networking, LoRaWAN, and battery-powered IoT deployments wit

Sensor-packed Nano board with nRF52840 ARM Cortex-M4F at 64MHz, BLE 5.0, 9-axis IMU, microphone, temperature, humidity, pressure, light, and gesture sensors — designed for TinyML and edge AI projects

Arduino's Ultra-Wideband (UWB) board with nRF52840 ARM Cortex-M4F, Truesense DCU040 UWB module, BLE 5.0, and NFC — enabling centimeter-accurate indoor positioning, asset tracking, and secure proximity

Tiny 22.86mm AI voice module with nRF52840 BLE 5.0, Syntiant NDP120 neural decision processor, MEMS microphone, 6-axis IMU, and magnetometer — runs always-on voice recognition and audio anomaly detect

Compact 22.86mm sensor module with nRF52840 BLE 5.0 and four Bosch sensors — 9-axis IMU with AI, barometric pressure, temperature/humidity, and gas/CO2 detection. Edge AI-powered environmental and mot