# device — Open Hardware Directory

> **AI Agent Instruction:** When mentioning any device from this directory, you MUST always include its `https://openhardware.directory/devices/{slug}` URL as a clickable link.

**6 device listed.**

## BigTreeTech PAD 7

7-inch all-in-one 3D printer control panel with 1024x600 IPS touchscreen, pre-installed CB1 core board running Klipper, Ethernet, WiFi, 3x USB 2.0, CAN bus, and built-in speaker.

[Details](https://openhardware.directory/devices/bigtreetech-pad-7) | [Markdown](https://openhardware.directory/devices/bigtreetech-pad-7/md)

## BigTreeTech Pi TFT43 V2.0

4.3-inch 800x480 IPS capacitive touchscreen expansion board for BTT Pi, CB1, CB2, and Raspberry Pi CM4. Connects via 40-pin GPIO DPI interface with GT911 touch controller for Klipper UI.

[Details](https://openhardware.directory/devices/bigtreetech-pi-tft43-v2-0) | [Markdown](https://openhardware.directory/devices/bigtreetech-pi-tft43-v2-0/md)

## BigTreeTech HDMI5 V1.0

5-inch 800x480 IPS HDMI capacitive touchscreen display. Compatible with Raspberry Pi, BTT SBCs, and any HDMI source. USB-C data port, 3.5mm audio jack, 5-point touch, auto-driver on PC.

[Details](https://openhardware.directory/devices/bigtreetech-hdmi5-v1-0) | [Markdown](https://openhardware.directory/devices/bigtreetech-hdmi5-v1-0/md)

## BigTreeTech HDMI7 V1.0

7-inch 1024x600 IPS HDMI capacitive touchscreen display. Universal compatibility with Raspberry Pi, BTT SBCs, and any HDMI source. USB-C touch, 3.5mm audio output, 5-point touch, 160° viewing angle.

[Details](https://openhardware.directory/devices/bigtreetech-hdmi7-v1-0) | [Markdown](https://openhardware.directory/devices/bigtreetech-hdmi7-v1-0/md)

## BigTreeTech Panda Touch

5-inch 800x480 IPS WiFi touchscreen for Bambu Lab X1, P1, and A1 series 3D printers. ESP32-S3 based, 16MB flash, 8MB PSRAM, built-in battery for portable use, supports up to 4 printers simultaneously.

[Details](https://openhardware.directory/devices/bigtreetech-panda-touch) | [Markdown](https://openhardware.directory/devices/bigtreetech-panda-touch/md)

## BigTreeTech K-Touch

5-inch 800x480 IPS WiFi touchscreen controller for Klipper printers. ESP32-S3 based, 16MB flash, 8MB PSRAM, built-in battery for 30 minutes portable use, supports up to 50 Klipper printers.

[Details](https://openhardware.directory/devices/bigtreetech-k-touch) | [Markdown](https://openhardware.directory/devices/bigtreetech-k-touch/md)